Exhaust Hoods

Power Test Dynamometer Exhaust Hood

Uses an exhaust fan to pull cool make-up air into the room as it evacuates hot air and exhaust gases from the room. Contact a Power Test representative for more information or to configure a room exhaust system for your application requirements.

Taylor Dyno Exhaust Hood

A hood style exhaust system pulls make-up air into the test cell while removing both engine exhaust and room. This open exhaust system does not require any engine connections, reducing the test time and labor involved with setup. A small ventilator should be installed into the ceiling to permit the escape of any fumes not captured.

Power Test Dynamometer Exhaust Hood Features:

• Exhaust hoods made from 18 GA galvanized sheet metal with integrated hanger brackets
• Variable Frequency Drive (VFD) motor controller with remote fan speed adjustment
• Exhaust hood sizes vary per application
• Customized system configuration may include, but is not limited to, the following options:
  • Adjustable hood height
  • Stainless steel

Taylor Dyno Exhaust Hood Features:

• Canopy style exhaust hood, fabricated out of steel with a powder coating
• Various hood sizes available
• Internal baffle increases fume capture velocity
• Temperature resistant up to 1,000°F (537°C) fiberglass strips front and rear to facilitate a safe vehicle entering and exiting
• Roof-mounted fan for accessibility and easier maintenance up to 40,000 CFM
• Fan comes with rain cap and gravity operated dampers
• Customer supplies roof curb, motor starter and duct from canopy to fan